If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Anthems and Protests ---
While we certainly understand the frustration by fans on all sides of the discussion, we have decided to keep the Broncos Country message boards separate from politics. Recent events have brought the NFL to the forefront of political debates, but due to the highly emotional and passionate discussion it tends to involve, we think it’s best to continue to keep politics and this forum separate. Yes, the forum is meant for discussion, but we’d like to keep that discussion to football as much as possible.
With everything going on in our country, it would be nice to keep our complaints and cheers purely related to football here. If you feel passionately, there are plenty of other outlets available to you to express your opinions. We know this isn’t the most popular decision, but we ask that you respect it.
Thank you for understanding.
--Broncos Country Message Board Staff
I thought I would paint my spare controller tonight and figured I'd share the progress.
The last picture is bad lighting but it's a maple orange which is not far from burnt orange that denver uses.
sucks that the touch screen isnt working, im sure you could disassemble it and figure out why its not.
i wanted to do this but i felt like the paint would make the controller feel tacky after holding it awhile, does it?
Yes it does I think it needs to finish curing which can take 2-3 days. I think it could have benefited from a clear coat as well. I'm not using it right now. Once it has finished curing I think I'll take it back apart. I suspect that the end of the ribbon that plugs into the touchscreen may have dislodged and I was too busy focusing on the end that plugged into the main circut board.
sucks that the touch screen isnt working, im sure you could disassemble it and figure out why its not.
i wanted to do this but i felt like the paint would make the controller feel tacky after holding it awhile, does it?
Still feels a bit tacky. When I take it apart again to install the thumbsticks I'm going to sand it, toss another coat of orange and let it cure. It sounds like I put too many coats on too soon. I should have waited a few extra hours between each coat.
Tweet
Comment